Opioid Toxicity & Conversion
The Patch
6 questions
Question 1 · Reading the Patch
Correct answer: 60–90mg
Why
Fentanyl 25mcg/hr is approximately 60–90mg of oral morphine per 24 hours.
- It is a wide range for a reason — conversion is approximate, and this is why patches are titrated against effect rather than calculated precisely
- The number matters because you have to include the patch when you add up someone's total opioid load. A patch is easy to miss on a drug chart, and easier still to miss on the patient
- Look for it. Patches are worn on the chest, upper arm or back and are frequently not documented
- Getting this wrong by a factor of two or three is how accidental overdose happens
Key point
25mcg/hr ≈ 60–90mg oral morphine daily. Find the patch before you add up the dose.
Question 2 · Speed
Correct answer: Patches are slow on and slow off, so they are unsuitable for rapidly changing requirements
Why
Fentanyl patches are slow on and slow off. It takes many hours to reach a new steady state after a change, and just as long for the effect to wear off.
- That makes them excellent for stable pain and poor for rapidly changing requirements — increasing the patch will not help him this afternoon
- Use immediate-release breakthrough doses to control the pain now, and titrate the patch against how much breakthrough he is using
- Heat increases absorption — a hot bath, a heat pad, a fever, or a hot ward can all significantly increase delivery from a patch and cause toxicity
- Patches can certainly be increased; the constraint is the timescale
Key point
Slow on, slow off — and heat increases absorption. A febrile patient in a hot ward is getting more than you prescribed.
Question 3 · He Becomes Toxic
Correct answer: No — a depot remains in the skin and absorption continues for many hours, so he needs titrated naloxone and prolonged monitoring
Why
Removing the patch does not stop absorption. A subcutaneous depot has already formed and continues to release fentanyl for many hours afterwards.
- He needs titrated naloxone: dilute 400mcg to 10ml, give 0.5–1ml (20–40mcg) every 2 minutes, titrated to respiratory rate, not GCS
- Naloxone's half-life is shorter than the opioid, and here the opioid keeps arriving — so repeat doses or an infusion are very likely to be needed, with prolonged monitoring
- Removing the patch is correct and necessary; it is simply not sufficient
- RR below 8 not responding to titrated naloxone is an escalation trigger for critical care
Key point
The depot outlasts the patch. Expect re-sedation for hours and plan for an infusion, not a single dose.
Question 4 · Titrating
Correct answer: Dilute 400mcg to 10ml and give 20–40mcg every 2 minutes, titrating to respiratory rate rather than conscious level
Why
Dilute 400mcg to 10ml and give 0.5–1ml — 20 to 40mcg — every 2 minutes, titrated to respiratory rate, not GCS.
- In patients on regular opioids, full doses cause a pain crisis — severe pain, agitation, hypertension and arrhythmia. He has metastatic pain controlled by a patch, and stripping it entirely is a serious harm
- The full 400mcg is reserved for arrest or apnoea
- IM cannot be titrated and its absorption is unpredictable
- The aim is breathing safely, not awake
Key point
Titrate to breathing, not to consciousness. Full reversal in a patient with cancer pain is its own emergency.
Question 5 · The Dying Patient
Correct answer: Keep it on, and add a syringe driver for additional requirements
Why
Keep the patch on in dying patients. The pathway states it explicitly in the drug notes.
- Removing it loses established background analgesia, and the slow off-set means the patient becomes uncovered over hours — at exactly the wrong moment
- Additional requirements are met with a syringe driver and PRN doses on top of the patch
- The patch continues to deliver reliably even when the patient can no longer swallow, which is precisely why it is useful here
- Complex conversions — methadone, high doses, patches — need specialist input
Key point
Leave the patch on when someone is dying. Add a driver on top; do not try to convert it away.
Question 6 · After Any Change
Correct answer: Sedation score, respiratory rate and saturations — sedation score precedes respiratory depression
Why
Sedation score precedes respiratory depression. That single fact is why sedation is monitored rather than only the respiratory rate.
- Respiratory rate and saturations after dose changes, alongside the sedation score
- By the time the respiratory rate has fallen, you have missed the earlier and safer warning
- Pain score alone will miss the patient who is comfortable because they are over-sedated — the two look identical on that scale
- Palliative care for complex cases, and remember that recurrent toxicity means root-causing the prescribing system
Key point
Sedation score first. By the time the respiratory rate drops you have missed the warning you were given.
Case complete
Practice on this page does not update your app progress. Open the browser app if you want its learning tools and progress record.